Load and Unload Assist by using another resource

LAYOUT CONFIGURATION | PROCESS MODELING

This video teaches how to assign a resource to assist another resource for loading and uploading parts. Using Essentials version is enough to do the tutorial, except the step that you need to create the “AssistLocation” frame requires using the Modeling tab which is available in Professional version or higher.

Note: This lesson assumes you are familiar with Process Modeling basics and how to create a layout using this library. To learn about Process Modeling, check out the course “Introduction to Process Modeling“.

Software Version: 4.3.0

What did you think about the lesson?

3 answers.

SIMILAR CONTENT

13:03

Layout Configuration

Process Modeling Flow Editor advanced features

In this video you will learn about two advanced features of the Process Modeling Flow Editor in Visual Components

30:20

Layout Configuration

Process Modeling Flow Editor

In this video you will learn some of the advanced features of the Process Modeling Flow Editor in Visual Components.

14 pages

Layout Configuration

Warehousing components reference

Introduces warehouse components in the eCatalog, their properties, and simple use cases.

PROCESS MODELING

21 pages

Layout Configuration

Process Modeling Resources Manual

Generic manual for Process Modelling resources such as mobile robots, humans, and forklifts.

PROCESS MODELING

25 pages

Layout Configuration

Robot Transport Controller - Manual

Learn how to use the Robot Transport Controller component. This will describe the basic use on high level and documents all the properties found on the property panel tabs in detail.

PROCESS MODELING

17 pages

Layout Configuration