‹ Back to all lessons

Idling and Charging of Resources

LAYOUT CONFIGURATION | PROCESS MODELING

Idle and charging locations are defined by placing idle or charging location components around the layout and must be connected to the Transport Controller trough “Idle/ChargingLocations” interface. This tutorial shows how to use these components.

Note: This lesson assumes you are familiar with Process Modeling basics and how to create a layout using this library. To learn about Process Modeling, check out the course “Introduction to Process Modeling“.

Software Version: 4.3.0

FORUM

What did you think about the lesson?

5 answers.

SIMILAR CONTENT